The main maintenance tip for ATV (All-terrain vehicle) is cleaning. Dirt bikes as well as motocross bikes are purpose-built for all-terrain tracks. After a thrilling experience at the track, the bike is dirty and caked with mud, thus requiring cleaning. This task can prove overwhelming due to exhaustion. It is important not to leave the bike in such conditions overnight. For a bike to last longer, the cleaning process is crucial. Riders will consider heading straight to the carwash, getting the pressure washer hose, blasting the bike with a pressure washer until every mud clamp falls off. This method of cleaning wears out the seat foam of your bike, ruins your rubber seals, damages your bearings over time, and harms the brake pads or discs. To prevent this, here are some tips to ensure your ride is intact after a deep wash.
Remove and Cover Sensitive Bike Parts
Dirt bikes require primary care before exposing them to water since washing involves direct water streams to the bike. Tokyomods.com shows you the parts to remove and safeguard seats since foam inside them soaks up water and deteriorates, damaging the bike. Reinstall the bolts after removing the seat to prevent the shrouds from wobbling. Remove the air filter as wetting leads to irreparable damage. Remove handguards, skid plates, and exhaust guards to allow extraction of all dirt, grease, and grime. After removal, cover the airbox with duct tape or airbox cover to ensure its safety. Cover the muffler using wash plugs or duct tape to ensure water does not go through into the pipe to safeguard your engine.
Wash and Scrub the Bike
Although pressure hosing gets the job done with minimal effort, it harms your bike. It is easy to get water into sensitive areas ruining your ride. Pressure washing also ruins your bike’s plastic parts and graphics. If you must use pressure, be careful when housing areas around the engine. Hose it at a considerable distance to avoid knocking your ride down with the pressure. After clearing all the mud, dirt, and grime from the surfaces, scrub the bike using bike brushes. These brushes are ideal for getting tough pieces of junk left over from housing in areas such as the chain, sprockets, and wheels where mud and dirt build-up. Ensure you scrub the underside of the bike to remove dirt still trapped on the bottom.
Sponge the Bike
Upon scrubbing and rinsing away all the mud and dirt, lather up the bike using a sponge, soft brush, or a wash mitt. Ensure that you get to the larger areas of the bike. Let the bike rest for about two minutes for the soap to penetrate any grime remaining to achieve sparkling clean results. Rinse with water and be keen where the soap goes.Bike Wash is recommended for extra shine in areas worst hit by grime, dirt, and grease. You apply this to the desired parts and then wipe it down.
Dry Off, Chain, and Reassemble
Using a clean, dry towel or a microfiber cloth, dry off your bike. For smaller and tight bike areas that are challenging to reach, use compressed air. This keeps rust and mildew growth off the dirt bike. Dry the brushed-up chain with compressed air to ensure no leftover water droplets and lubricate it. After your bike is clean and shiny, remove anything you may have used to safeguard the engine, like duct tapes, plugs, and caps, and put back the parts you initially removed.
For more useful information regarding UTV parts and tips, visit Rad.Parts. You’ll find out a lot of stuff you didn’t know about side-by-side vehicles and off-roading in general.
Hey welcome to my blog . I am a modern women who love to share any tips on lifestyle, health, travel. Hope you join me in this journey!
Speak Your Mind